Tv guard 13ah....

Without doubt, power interruptions cause major problems for home and business computing. An unpredictable power supply can lead to worrying problems events such as surges, spikes, brownouts and utility failures. If any of these should occur, there’s a strong chance you will suffer from loss of critical data, lowered productivity and even damage to your expensive equipment.

All electrical and electronic equipment, connected to the mains supply is at risk of being damaged from spikes, surges, lightning, brown-outs, power-cuts (blackouts), power back surges, and over-voltage.

FK encompasses a wide range of power protection products for use in many different industries where clean, regulated mains power is critical to their continued operation.

The FK TV/DVD guard is an overvoltage protection device rated at 13 Amps. The TV guard will disconnect if the mains go above the upper limit and re-connect automatically after the supply returning and remaining below the upper limit for the duration of the wait time.

PLEASE READ CAREFULLY1. Make sure that your load does not exceed the rating of the TV guard which is 13 AMPS. If this is exceeded, the TV guard may be damaged, and the warranty will be void.2. Plug the TV guard into the mains and plug your appliance into the TV guard.3. Do not connect more than one appliance to the TV guard4. On first switching on, the red LED will indicate and there will be no output while the TV guard monitors the mains. If the mains level is acceptable, the Yellow LED is lit indicating that the TV guard is in wait mode. At the end of the wait time, and if the supply is below the upper limit, the green LED goes on and the load is connected.5. It is recommended that the TV guard is kept switched on, and the appliance switched on and off as required, to prevent activating the time delay every time the appliance is switched on.

THE FRIDGE GUARD

The FK Fridge/Freezer Guard is an under-voltage protection device rated at 13 Amps. The Fridge Guard will disconnect if the mains go below the lower limit and re-connect automatically after the supply returning and remaining above the lower limit for the duration of the wait time.

PLEASE READ CAREFULLY1. Make sure that your load does not exceed the rating of the Fridge Guard which is 13 AMPS. If this is exceeded, the Fridge Guard may be damaged, and the warranty will be void.2. Plug the Fridge Guard into the mains and plug your appliance into the Fridge Guard.3. Do not connect more than one appliance to the Fridge Guard.4. On first switching on, the yellow LED will indicate and there will be no output while the Fridge Guard monitors the mains. If the mains level is acceptable, the Yellow LED is lit indicating that the Fridge Guard is in wait mode. At the end of the wait time and if the supply is above the lower limit the green LED goes on and the load is connected.5. It is recommended that the Fridge Guard is kept switched on, and the appliance switched on and off as required, to prevent activating the time delay every time the appliance is switched on.6. If the red LED shows, the voltage is too low. When the voltage is acceptable, the Fridge Guard will go to yellow.

SPECIFICATIONS• Nominal Voltage 230V (or 110V)• Current Rating 5Amps• Frequency 50/60Hz• Mains Spike Response Time less than 10ns• Mains Spike Discharge Amps 6.5kA • Spike Protection 160J• Ideal For Fridges, freezers and coolers• Weight 250gm• Dims 180x90x95mm

Key Features

High Voltage disconnect 

Low Voltage protection

Microprocessor control

Spike/surge protection

Power back surge protection

Lightning protection

Heat resistant hard ABS plastic to withstand overheating

Safety shuttered sockets

Ideal for all electrical devices

Ideal for both indoor & outdoor

What’s in the box

FK TV Guard

FKFridge guard